Sennheiser HD400 Manual do Utilizador descarregar pdf (Página 38)

Amp, Cab & Mic Models

5•8

FX Only Mode

Use the “FX Only” mode if you prefer to keep the Amp, Cab & Mic models’ processing

bypassed, such as to use only the unit’s FX if running POD HD into a guitar amp. The

following behaviors apply for the FX Only mode:

• To toggle FX Only mode on/off, simply toggle the FX ONLY button, which remains

lit when this mode is active.

• The FX Only mode is a persistent, “global” setting, therefore, the Amp, Cab & Mic

processing remains bypassed when the mode is active, regardless of the Amp Model’s

enabled/disabled state saved within any Preset.

• Since the FX Only mode bypasses the Amp, this also means the Amp’s tone knobs

and Amp Edit Mode parameters are disabled. Therefore, when the Amp is off, a

“Bypass Volume” parameter is provided to allow signal level adjustment - see “Bypass

Volume” on page 5•6.*

• The Reverb effect is still available when in FX Only mode, and fully adjustable via

the REVERB knob, as well as via the Edit mode - Reverb menu.

* Note that the Amp & Cab processing can also be bypassed via the AMP footswitch,

however, the footswitch only bypasses the Amp for the current Preset.

AutoFX SETUP Parameter

This option is a global setting, offered in the SETUP menu. Please see “AutoFX” on page

1•2. This setting will affect the FX behaviors when selecting a new Amp Model via the Amp

select knob.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 80 81

Sem comentários

Sennheiser HD400 Manual do Utilizador Página 38