Sennheiser EW 300 IEM G2 - ANNEXE 141 Guia do Utilizador descarregar pdf (Página 22)

Updating the firmware in the devices

The firmware is automatically updated in the following order:

1. NET 1

2. Rack-mount devices

3. Portable devices

To start the firmware update:

왘 Click on “Start”.

왘 Follow the instructions of the wizard.

Note:

After the firmware in the NET 1 has been updated, the device restarts.

This can take up to one minute.

Risk of data loss if transmission is interrupted during

firmware update!

Data may be lost if the transmission is interrupted. The

devices may also be damaged as a result.

When updating the firmware, do not interrupt any

device connection to the NET 1 or to the rack-mount

devices.

Do not disconnect power from the devices. Preferably

use fully charged batteries for the portable devices!

Since the updating process takes about 40 seconds,

firmly position the portable devices in front of the

infrared interface.

Place the portable devices in front of the infrared

interface of the NET 1 until a corresponding message

appears in the wizard window.

CAUTION!

왘

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Sem comentários

Sennheiser EW 300 IEM G2 - ANNEXE 141 Guia do Utilizador Página 22