Sennheiser NET 1 Especificações descarregar pdf (Página 11)

Fitting the device feet (table top device only)

To ensure that the NET 1 cannot slip on the surface on which it is placed when

using it as a table top, fix the supplied four self-adhesive soft rubber feet to

the base of the NET 1.

왘 Ensure that the base of the NET 1 is clean and free from grease before

fitting the rubber feet.

왘 Fix the rubber feet to the base of the NET 1 by peeling off the backing

paper and fitting them as shown in the diagram on the left.

Caution!

Some furniture surfaces have been treated with varnish, polish or

synthetics which might cause stains when they come into contact with

other synthetics. Despite a thorough testing of the synthetics used by us,

we cannot rule out the possibility of staining.

Connecting the power supply

Connect the power supply, but keep the NET 1 switched off.

왘 Connect the supplied power cord to the socket .

왘 Connect the power cord to a wall mains outlet.

Connecting the receivers

The NET 1 has five connection groups for two receiving channels each. To each

connection group, you can connect either

y two evolution wireless G2 receivers via the RJ 10 sockets 

y one EM 3532 twin receiver via the sub-D socket .

Connecting evolution wireless G2 receivers

왘 Use separate RJ 10 cables to connect the service interface (DATA) of each

evolution wireless G2 receiver to the desired RJ 10 socket  on the NET 1.

왘 When connecting an EM 550 G2 twin receiver, connect the individual

receivers RX A / RX B to the NET 1.

Note:

Make sure that the number of connected receivers per frequency range

does not exceed the number of free preset frequencies within a channel

bank (see also page 19).





DATA

NET 1

EM 300 G2



Series Max. number of connectable receivers per frequency range

ew 300 G2 8

ew 500 G2 20

ew 550 G2 20

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Sem comentários

Sennheiser NET 1 Especificações Página 11