Sennheiser NET 1 Especificações descarregar pdf (Página 20)

"Master/Slave” operating mode

왘 Connect two NET 1 as described under “Connecting two NET 1” on

page 13.

You can connect up to 20 receivers to two NET 1. They may even belong to

different frequency ranges. However, the number of receivers from one

frequency range may not exceed the number of channels in one channel bank

of the receivers.

Example:

An EM 300 G2 has eight preset channels in a channel bank, allowing you

to connect a maximum of eight EM 300 G2 receivers from the same

frequency range to the NET 1 system. Any additional receivers that you

connect to the NET 1 system must use a different frequency range.

The operation of the two NET 1 in the “Master/Slave” operating mode differs

from the “Single Device” operating mode only with regard to the frequency

preset scan (refer to next chapter). All other operating steps on the “master”

NET 1 are similar to the “Single Device” operating mode (see from page 19

onwards).

Performing the frequency preset scan with two NET 1

To perform a frequency preset scan, proceed as follows:

왘 On one of the two NET 1, press and hold the MODE button .

The NET 1 whose MODE button  you have pressed becomes the

“master” NET 1 and controls the second or “slave” NET 1. While pressing

the MODE button  on the “master” NET 1, the “slave” NET 1’s

y "DATA LINK” LED  goes off,

y the “REMOTE"  and “SCAN” 쐋 LEDs light up,

y and the MODE button  is deactivated.

After you have released the MODE button  on the “master” NET 1, the

“slave” NET 1’s

y “REMOTE”  and “SCAN” 쐋 LEDs go off,

y the “DATA LINK” LED  lights up,

y and the MODE button  is reactivated.

The NET 1 checks the frequency ranges of all connected receivers. On the

first receiver found for each frequency range, the “CHANNEL” LED 

lights up; this LED is off on all other receivers.

왘 Press one of the channel buttons  whose “CHANNEL” LED  is lit in

order to start the frequency preset scan for this frequency range.

After have pressed the channel button, this receiver scans its channel

banks and the “CHANNEL” LED  flashes. At the same time, the yellow

“SCAN” LED 쐋 flashes slowly.

”Remote” operating mode

For information on how to perform a frequency preset scan when a PC is

connected, please refer to the instructions for use of the “Wireless Systems

Manager” software.









1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Comentários a estes Manuais

Sem comentários

Sennheiser NET 1 Especificações Página 20

Comentários a estes Manuais