Sennheiser NET 1 Especificações descarregar pdf (Página 18)

Selecting a channel bank and transferring the scan result to the receivers

The receiver that has performed the frequency preset scan will then display

(for each channel bank) the number of free frequencies (channels). The

“CHANNEL” LEDs  of all receivers of this frequency range flash slowly.

Disturbed or occupied frequencies are blocked for frequency assignment.

왘 On the receiver that has performed the frequency preset scan, select a

channel bank with a sufficient number of free channels using the 왖/왔

rocker button (refer to the instructions for use of the receiver). The

selected channel bank must have (at least) as many free channels as

receivers from this frequency range are connected to the NET 1.

왘 Confirm your selection by pressing the SET button.

The NET 1 assigns the frequencies of the selected channel bank to all

connected receivers of the frequency range. The yellow “SCAN” LED 

goes off and the yellow “DATA LINK” LED  flashes slowly until the

frequencies have been transferred to all receivers.

Note:

If you have connected more receivers (from one frequency range) than

free channels are available in one channel bank, the NET 1 re-assigns the

last frequency assigned to the subsequent receivers.

Transferring frequencies to the transmitters of a frequency range after a

frequency preset scan

You can transfer the frequencies to the corresponding transmitters of the

system using the infra-red interface of the NET 1 (no cable required).

The infra-red interface of the bodypack transmitters is located in the battery

compartment.

왘 For data transfer, open the cover of the bodypack transmitter.

The infra-red interface of the hand-held transmitters and plug-on trans-

mitters is located under the display’s faceplate.

Note:

Strong extraneous light may interfere with the transfer of the

transmission frequencies via the infra-red interface. Therefore, position

the NET 1 so that any possible interference caused by extraneous light is

avoided. The arrow in the diagram on the left indicates the direction from

which the IR radiation must impinge upon the transmitter.

After the frequency preset scan, the NET 1 indicates that you can transfer the

frequencies to the transmitters as follows:

y The infra-red interface  is permanently backlit in blue.

y The “CHANNEL” LEDs  of all devices of one frequency range flash slowly.

y The yellow “DATA LINK” LED  flashes until all frequencies have been

transferred to the transmitters.

To transfer the frequency to the transmitter, proceed as follows:

왘 Switch on the transmitter as described in the instructions for use of the

transmitter.







SKM 500

SK 500

SKP 500



 

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Comentários a estes Manuais

Sem comentários

Sennheiser NET 1 Especificações Página 18

Comentários a estes Manuais