Sennheiser NET 1 Especificações descarregar pdf (Página 24)

25

Problems that may occur during operation

Problem Possible cause Possible solution

NET 1 has assigned the same

frequency to several evolution

wireless G2 receivers

You have connected more receivers

from one frequency range than there

are free channels in the channel bank.

Only connect as many receivers from

one frequency range as there are free

channels in the channel bank and

restart the frequency preset scan.

It is not possible to transfer the

frequency to the transmitter

The transmitter does not have the

latest firmware installed.

Update the firmware of the transmitter

(see “Updating the firmware” on

page 16).

The transmitter is not within the range

of the infra-red interface.

Place the transmitter at a distance of

approx. 10 cm in front of the infra-red

interface (see page 20 and page 23).

The infra-red interface of the NET 1 is

not yet ready for transferring the

frequencies. The NET 1 is still in scan

mode.

Press the MODE button  to cancel the

scan (see “Cancelling the frequency

preset scan or frequency transfer” on

page 20).

The transmitter is from a different

frequency range.

Use a transmitter that is from the same

frequency range as the receiver.

The red “ERROR” LED  flashes

rapidly for approx. 3 seconds

and the “CHANNEL” LED  for

the receiver flashes permanently

The frequency transfer to the

transmitter has failed.

Repeat the frequency transfer

(see page 19, page 20 and page 22).

The NET 1 does not react Restart the NET 1 (see “Restarting the

NET 1” on page 26).

The yellow “REMOTE” LED 

does not light up

Communication between the NET 1 and

the PC is disturbed.

Check the connections and cables.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Comentários a estes Manuais

Sem comentários