Sennheiser NET 1 Especificações descarregar pdf (Página 16)

Problems that may occur when putting the NET 1 into operation

Problem Possible cause Possible solution

The green “READY” LED  has

gone off.

The power cord is not connected

correctly.

Check if the power cord is connected

correctly.

The NET 1 is switched off. Switch on the NET 1.

The green “CHANNEL” LED 

does not light up, even though a

receiver is connected.

The cable of the corresponding receiver

is not connected correctly.

Check if the cable is connected

correctly.

A receiver of the evolution wireless G2

series is not switched on.

Switch on the receiver.

The cable between the NET 1 and the

receiver is defective or the connector

assignment is incorrect.

Replace the cable or check the

connector assignment (see “Connector

assignment” on page 28).

The corresponding connection group is

double-occupied: an EM 3532 twin

receiver is connected to the sub-D

socket and an evolution wireless G2

receiver is connected to at least one of

the two RJ 10 sockets.

Either remove the evolution wireless

G2 receiver(s) or the EM 3532 twin

receiver (see “Connecting the

receivers” on page 12).

One of the receivers RX 1 or RX 2 of the

connected EM 3532 twin receiver is not

being detected due to the fact that the

receiver was switched off when the

NET 1 was switched on.

왘 Switch off the NET 1.

왘 Switch on both receivers RX 1/RX 2

of the EM 3532 twin receiver.

왘 Restart the NET 1 (see “Restarting

the NET 1” on page 26).

The green “READY” LED 

flashes.

The NET 1 is being initialized (duration:

approx. 20 sec.) and is not yet ready

for operation.

Wait until the “READY” LED  lights

up permanently, indicating that the

NET 1 is ready for operation

The green “CHANNEL” LED 

flashes once every second.

The evolution wireless G2 receiver does

not have the latest firmware installed.

Update the firmware of the receiver

(see “Updating the firmware” on

page 16).

The assignment of the channel

buttons to the channels of the

EM 3532 twin receiver is

swapped.

Instead of the receiver RX 1, the

receiver RX 2 of the EM 3532 twin

receiver is connected to sub-D socket

on the NET 1.

Connect the receiver RX 1 of the

EM 3532 twin receiver to the sub-D

socket on the NET 1 (see “Connecting

the EM 3532 twin receiver” on

page 13).

The NET 1 does not react. Restart the NET 1 (see “Restarting the

NET 1” on page 26).

The yellow “REMOTE” LED 

does not light up.

Communication between the NET 1 and

the PC is disturbed.

Check the connections and cables.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

Comentários a estes Manuais

Sem comentários

Sennheiser NET 1 Especificações Página 16

Comentários a estes Manuais